GeoSync Microwave UPC
The GeoSync Microwave UPC (Uplink Power Control) System provides control of the uplink RF power, with up to 3 attenuator modules, each capable of 20 dB of uplink power correction. The UPC is designed to adjust the uplink signal strength to minimize weather-induced variations in signal strength received by geostationary satellites. The received signals can be from a telemetry beacon or a carrier transmitted from the RF terminal and looped back into the satellite.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 2.04 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection - SNMP Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to Use
The following data pages are available:
- General: Displays general information such as the model and serial number, the firmware revision, etc.
- System: Displays system information of the device, such as the date/time and alarms of the device. You can also change the algorithm, date/time, sample time, and idle time of the device.
- Channel: Provides channel monitoring and controls.
- Receiver: Provides receiver monitoring and controls
- Receiver Calibration: Provides receiver calibration controls.
- Log: Displays the Log Events table, with the total number of log entries displayed at the top. You can clear the entries in the table with the Clear button.
- Communications: Allows you to configure the IP address, subnet mask, gateway, and settings related to serial communication.