GlenSound Atomic Copper 29S

About

The GlenSound Atomic Copper 29S is a high-performance Telephone Balance Unit designed to interface with analogue telephone lines. A high-performance network echo canceller enables the unit to achieve excellent isolation between send and receive circuits.

This connector uses smart-serial communication in order to communicate with the device.

Installation and configuration

Creation

Serial main connection

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

• Interface connection:

  • IP address/host: The polling IP of the device.
  • IP port: The IP port of the device
  • Bus address: Not required.

Usage

This connector contains 5 pages.

General

This page displays the last received Status, and allows you to define the DTMF Dial Number. It contains 3 buttons: Go Off Hook, Go On Hook and Answer Go Off Hook.

Settings

On this page, you can configure settings, such as Disconnect Tone Coefficient, Disconnect Tone Threshold, Disconnect Tone Cadence, Disconnect Tone Off On, Country, Mute Rx and Tx, Acoustic and Line Echo Canceller, K-Break Disconnect, Tone Disconnect, Auto Answer, DAA FS, Conference Mode, Ducker, AGC, Noise Gate and B Leg Audio Function.

DAA Chiptset Pages

On these pages, you can configure settings regarding the DAA Chipset from the Register 100 to 159.