GlobeSat ACU9220S
The 9220S antenna control unit (ACU) is suitable for the automatic control for C or Ku band satellite communications earth stations and satellite television receiving only stations with two axes AC motorized control.
About
This connector is intended to communicate with 9220S Antenna Control System devices using serial commands as described in the device manual.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Not specified. |
Installation and configuration
Creation
Serial Main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device.
Usage
General
This page displays the Azimuth, Elevation, Polarization, AGC, Operation Mode, and ADU Status. The Error Message remain "not initialized" Until there is an Error in the system.
Rotation
This page displays an overview of Azimuth CW/CCW, Elevation UP/Down, and Polarization CW/CCW Rotation.
Limit
This page displays an overview of Azimuth CW/CCW, Elevation UP/Down, and Polarization CW/CCW Limit.
Soft Limit
This page displays an overview of Azimuth CW/CCW, Elevation UP/Down, and Polarization CW/CCW Soft Limit.