Gsertel RCS400
Gsertel's RCS400 DVB-T/T2 is a professional network monitoring platform that allows remote, proactive, simultaneous and real-time monitoring of up to 4 DVB-T/T2 digital television multiplex streams, both at RF and transport levels.
This connector can be used to monitor and control the device, as well as gather trend information.
About
The connector uses an SNMP connection to communicate with the device.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version. | No | Yes |
| 1.0.1.x [SLC Main] | Column IDX in table 8200 changed. | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 6.05 |
| 1.0.1.x | 6.05 |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
Usage
General
This page contains all the device-related firmware information.
Inputs
This page displays the RF Measures, ASI Measures and IP Measures tables.
In addition, it contains page buttons to the Spectrum, Polling RF Measures, Constellation, Polling IP Measures and IP Channels subpages, where you can find tables with further information.
Services
This page contains the Services, PCR and PID tables. The Services table lists all the available service names and IDs.
Transport Stream Alarms
This page contains the Ts Test Failure, Service Alarm Config and Service Alarm Polling Status tables
In addition, it contains page buttons to the subpages with the configuration and information for First Priority Alarms, Second Priority Alarms and Third Priority Alarms.
Input Alarms
This page contains the Alarm Summary table, as well as page buttons to the following subpages:
- RF Inputs: Displays RF alarm information and advanced alarm information.
- ASI Inputs: Displays a table with information on the alarm polling status.
- IP Inputs: Displays IP-related alarm information.
Web Interface
This page connects to the device web interface. However, note that the client machine has to be able to reach the device, as otherwise it will not be possible to open the web interface.