Harris NetVX AUD D14

The Harris NetVX AUD D14 connector is an SNMP connector that is Audio Converter.

About

The Harris NetVX AUD D14 is an overview of Encoders and Decoders configuration parameters that make it easier to configure this Audio Converter. Also the status of the Encoders and Decoders are shown.

Installation and configuration

The Harris NetVX AUD D14 connector has an SNMP Connection:

• Port: 161
• Bus address: The slot number of the Audio Converter.
• IP Address: The IP of the Device
• Get community string: public
• Set community string: private

Usage

General

Here you see some General Slot Configuration parameters, where you can make some basic changes to the Audio Converter and you also have the General Slot Status parameters that shows you some basic information about the Audio Converter. So you have some small overview already about the connector on this page.

Ctl Configuration

Certificate Trust List Configuration this presents all the trusted Coders for this slot. You can choose their Function (Decode/Encode/Off) and set their Mode (Standalone/Associated).

Encoder Configuration

This page has a TreeControl that shows you the Configuration of every Encoder on this slot. Each of these Encoders have an Audio Advanced Configuration, Audio Configuration, Event Configuration, New Event Configuration, Program Configuration and Router Control Configuration. These overviews shows you all details about the specific Encoder and gives you the possibility to make changes to the configuration.

Decoder Configuration

This page has a TreeControl that shows you the Configuration of every Decoder on this slot. Each of these Decoders have an Audio Configuration, Program Configuration and Router Control Configuration. These overviews shows you all details about the specific Decoder and gives you the possibility to make changes to the configuration.

Encoder Status

This page has e TreeControl that shows you the Status of every Encoder on this slot. Each of these Encoders have an Audio Status and a Program Status.

Decoder Status

This page has e TreeControl that shows you the Status of every Decoder on this slot. Each of these Decoders have an Audio Status and a Program Status.

Notes

It could happen that you make a new element of the connector and the TreeControls are empty, just recreate / reopen the element card and the problem is fixed.