Hiltron HACU
The Hiltron HACU is a complete high-precision motorized satellite antenna control unit. With this connector, you can monitor and configure the Hiltron HACU via an SNMP connection.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | - | - |
| 1.0.1.x | Connector review: spelling corrections, discrete updates, etc. | - | - |
| 1.0.2.x [SLC Main] | - Added Power Supply Table and renamed existing table to "Heater Power Supply". - Improved reset functionality (reset alarms is now similar to the web interface) and improved positioning. |
- | - Change to parameter name and descriptions. - Layout changes. |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
| 1.0.1.x | - |
| 1.0.2.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 1.0.1.x | No | Yes | - | - |
| 1.0.2.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection - Main
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP Connection:
- IP address/host: The polling IP of the device, e.g., 10.11.12.13.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device. The default value is public.
- Set community string: The community string used when setting values on the device. The default value is private.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element created with this connector consists of the data pages detailed below.
General
Displays general information.
Via the Polling Configurations page button, you can access a subpage with toggle buttons that allow you to enable or disable polling for the main parameter groups of the element. If polling is disabled, the affected parameters will show the N/A state. If you see a parameter that is not polled elsewhere in the element, check this subpage to see if the polling configuration is the cause.
Position
Displays information about the Azimuth, Elevation and Polarization angles and alarms.
Tracking
Allows you to enable, disable, configure and monitor the satellite tracking.
Satellite
Allows you to select a satellite and to direct the antenna to the satellite.
The Redundancy settings are available via a page button.
Beacon Receiver
Displays all parameters and settings regarding the beacon receiver.
Status
Displays the Wind and Level tables.
Heater
Displays different tables with heater statistics.
Via page buttons, you can access the Power Supply and Current readings.
Alarms
Displays the main alarms.