Huawei UPS AC
This connector can be used to monitor and configure Huawei UPS AC devices.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | -Displays relevant information about the outputs, inputs, bypass and parallel systems. -Displays active alarms. |
- | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | V100R003C01SPC411 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element created with this connector consists of the following data pages:
General: Displays general information about the device such as the Number of Devices, Number of Parallel Systems, Environment Temperature and Humidity.
Input and Output: These two pages display information regarding the inputs and outputs, such as the Voltages, Currents and Frequency.
Bypass: Displays information about the bypass, including the Voltages and Frequency.
Battery: Displays the Battery table, which contains information such as the Voltage, Current, Capacity and Temperature of the batteries.
Via a page button, you can also access the Battery Scheduled Test subpage, where you can configure the discharge tests. You can adjust the Time Limit, Time Interval, Discharge Rate and Maximum Discharge Rate of the tests.
Parallel System: Contains information about the parallel systems, such as the Active Power, Apparent Power and Load Factor.
Alarms: Contains the Active Alarms table.
Control: Displays the Control table, where you can configure the Power On Settings, Power Off Settings, Battery Manual Boost Charge, Battery Manual Float Charge, Battery Shallow Test, etc.