Huawei iBMC
About
The Huawei iBMC or Intelligent Baseboard Management Controller is an embedded server management system that is used to manage servers throughout their lifecycle.
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 3.31 (U4282) iBMC SW on Huawei FusionServer 2288H V5 |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
How to use
On the General and System page, you can find information related to the system.
The CPU, Memory, Hard Disk, Fans, Power, Network, PCIe and SD Card pages show the overall alarm status for that aspect of the system and contain a table with detailed information.
The Sensors and Temperature pages display the detailed sensor readings and thresholds.
The Alarms page contain the Active Alarms Table. This table displays a list of all Active Alarms received from the server. If a de-assert event is received for a specific event, that event will automatically be removed from the table. Note that the connector was developed and tested with the device configured to use "OID" mode for the trap notification settings. It is therefore recommended to use the connector in combination with the Trap OID mode on the device itself.
On a subpage, the Trap Table is included, where you can view all incoming traps from the server with their raw information. It is possible to limit the number of traps by a maximum number of traps or number of days.