IMCI Open-I XL
This connector is used to monitor IMCI Open-I XL devices, i.e., SNMP-based Network Element Managers.
About
With this connector, it is possible to monitor IMCI Open-I XL devices, such as the IMCI Open-I 200XL and 1000XL series, with SNMP.
The different parameters from the device are displayed on multiple pages according to the subject of the parameters.
The connector implements traps to update the corresponding values and to generate alarms immediately.
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 14.5.0, 15.5.0 |
Installation and configuration
Creation
SNMP main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g., 10.11.12.13.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string needed to read from the device. The default value is public.
- Set community string: The community string needed to set to the device. The default value is private.
Usage
General Page
This page displays general information, such as:
- Model name
- Software Version
- IP information
- Time information
- Power supply information
Contact Input Page
This page displays a table where you can configure the Contact Inputs.
Contact Outputs Page
This page displays a table with the Contact Output states and configuration settings for each output.
Config Page
On this page, it is possible to configure Traps, Rules and Dial in settings
Logs Page
This page displays a table with the logs of the device. The logs can be cleared with the Clear Log button.
Comm Ports Page
This page displays a table with the comm port states and configuration settings for the comm ports.
Interfaces Page
This page displays a table with the interface states and configuration settings for the interfaces.
Ext Services Page
This page displays a table with the external services and configuration settings for the services.
Access Page
This page displays a table with the access settings, such as:
- Access Type
- Community
- IP Address
- Port Number
Traps Page
This page displays a table with the traps and their Severity Value and Level.
Session User Page
This page displays a table with the users of the IMCI Open-I XL system with their settings.
Serial Session Page
This page displays a table with the current serial sessions.
Analog Input Page
This page displays a table with the analog inputs of the system and configuration settings for the analog inputs.
Event Correlation Page
This page displays a table with the event correlations. It is also possible to enable or disable event correlation here.