IRT SSPA Series
About
This connector is used to monitor and configure an IRT SSPA Series device.
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 2.12.10 |
| 1.0.1.x | 2.12.10 |
Configuration
Connections
SNMP Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device. By default public.
- Set community string: The community string used when setting values on the device. By default private.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
These are the main data pages of the connector:
- The Monitor page is the default page. Here you can find information about Input and Output power, Device Temperature, and Mute status.
- The General page displays general information about the connector, such as the Name and Location of the device.
- The Alarms page contains the System Alarms Table, which shows information about alarms such as the Description, Status, and Device Name.
- On the Control page, you can change Mute and Gain values.
- On the Configuration page, you can configure the Center Frequency and Attenuation Offset. On the LO Settings subpage, you can find the LO Frequencies table.
- The Redundancy page contains information about the redundancy members.