ITNM Systems IDM100 Service

The ITNM Systems IDM100 Service connector is used to display information about one particular service from the ITNM Systems IDM100 analyzer. The connector uses a serial connection to send HTTP commands to the device.

About

The ITNM Systems IDM100 Service connector sends HTTP commands to the IDM100 over a serial connection. The connector only polls the service information from one of the services of the ITNM Systems IDM100.

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

• IP address/host: The polling IP of the device, e.g., 10.11.12.13.
• IP port: The port of the connected device, e.g., 81.

Usage

This connector has 5 pages: General, PIDs, Audio / Video, PCR / PTS/ DTS and Web Interface.

General Page

The General page displays general information about the service. For example: the Service Type, Total Bandwidth, etc.

PIDs Page

The PIDs page displays the Service PIDs table. This table has an entry for each PID in this particular service.

Audio / Video Page

The Audio / Video page displays 2 tables: Audio PIDs and Video PIDs. The audio PIDs from this service will be displayed in the Audio PIDs table, while the video PIDs will be displayed in the Video PIDs table.

PCR / PTS / DTS Page

The PCR / PTS / DTS page contains extra information about the errors and performance of the service.

Web Interface

The Web Interface page can be used to access the web interface of the device. Note that the interface must be accessible from the client PC.