Imagine Communications DA-S6802+
The Imagine Communications DA-S6802+ connector uses both serial and smart-serial communication. It can be used to monitor and configure an amplifier card in an Imagine Communications frame. It allows alarm monitoring of all important parameters.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | N/A |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (fixed value: 4050).
- Bus address: The bus address of the device (range: 0 - 100).
Serial PortDev Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (fixed value: 4000).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
On the Alarms page, you can find several alarm parameters (Loss of Input, Input Not Locked, and Loss of Looped Output). The state of the alarms can be "Alarm Inactive" or "Alarm Active". Alarm monitoring can be configured on these parameters. For each alarm, two buttons are available that allow you to enable or disable the alarm on the device.
On the Input page, the Other page button provides access to signal presence information. The Output page also contains such a page button, which allows you to configure the Slew Rate.
On the Processing page, you can find the Serial Number and configure the License Key. This page also has an Other page button, which allows you to configure the Loss of Input Alarm.
Notes
As this is a serial connector with a smart-serial connection, there has to be a connection to a real device. If there is a change on the device, a response will be pushed to the DMA, without the need to send a poll request.