Table of Contents

Imagine Communications VAX SD DMB IRTDAB Np1

This connector is used to monitor an Imagine Communications VAX SD DMB IRTDAB Np1 transmitter device.

About

This connector retrieves 15 parameters from the device. Data is polled via SNMP. The connector supports traps: each parameter is associated with a trap and trap sending can be enabled/disabled for each parameter.

Installation and Configuration

Creation

SNMP Main Connection

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device, e.g. 10.11.12.13.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string used when reading values from the device, by default public.
  • Set community string: The community string used when setting values on the device, by default private.

Usage

This connector contains 2 pages.

General

This page displays 7 different groups of control parameters. Each group contains a main parameter, a parameter to enable/disable the corresponding traps and a priority parameter.

There are also three configuration parameters. Event Counter Monitoring is used to switch between the two kinds of traps monitoring:

  • If this parameter is enabled: when a trap is received, the binding 'Event Counter' is read. If two successive traps have an 'Event Counter' binding separated by more than Event Counter Threshold, all parameters are polled again.
  • If this parameter is disabled: when a trap is received, the corresponding parameter is polled again.

The Refresh button is used to force the polling of the data.

Faults

This page displays 8 different groups of monitoring parameters.

Improve this page