Infothuis DST100

The Infothuis DST100 is used to restamp timing data and to model subtitles.

About

The Infothuis DST100 connector is used to monitor a DST100 device. This connector uses SNMP communication to retrieve data from the device.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP of the device, e.g., 10.11.12.13.
• Device address: Not used.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string in order to read from the device. The default value is public.
• Set community string: The community string in order to set to the device. The default value is private.

Usage

General

The General page displays the System and Service Contact Information and the overall status of the device.

Health Monitor

The Health Monitor page displays values from the monitor device fan, voltage and temperature readings.

DST

This page gives an overview of the subtitles information.

ASI

This page gives an overview of the devices used as transmitter or receiver, as well as their status.

Web Interface

Shows the webpage of the device.