International Datacasting Star3
The International Datacasting Star3 is an integrated receiver/decoder device (IRD). This connector allows complete monitoring of such devices.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | No | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- IP port: The IP port of the device.
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
How to use
The element consists of the following data pages:
- General: Contains clock-related parameters as well as firmware information and general hardware details. Also provides access to the Set Input, Service Info, Device Info and Polling Config pages, and allows you to manually Refresh data and Reboot the device.
- DVBTS: Contains basic parameters related to DVBTS, namely PIDs, MPE PIDs, Flexkey IP and Port, TS-Input and Audio Mode.
- Decoder: Contains information about all audio and data channels.
- Alarm: Allows you to monitor the device with a complete set of alarm and notification parameters.
- Control and Output: Contains information regarding the control input and output configuration, including ASI and IP details.
- Measurements: Contains generic information regarding Control Mode, NCCF and Audio Status. Also provides access to Measurements Input and Measurement Decoder pages.