Inverto IDLV-5x00
This connector is used to manage and monitor the Inverto IDLV-5x00.
About
With this connector, you can manage and monitor the professional multi-format HDTV integrated receiver decoder Inverto IDLV-5x00 via SNMP polling.
SNMP traps can be retrieved when this is enabled on the device.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | Yes | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 51PR0022 |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- IP port: The IP port of the device.
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Usage
General
This page contains module-specific hardware information.
Status
This page displays status information for the DVB-S2 Tuner and ASI1/ASI2 inputs.
Tuner
This page contains DVB-S2 configuration parameters.
CI
On this page, the CI Source can be selected from the available input list. It is also possible to set the corresponding CI Programs list on each CI slot.
Decoder
This page contains page buttons that open the following subpages:
- Decoder Play: Allows you to select the input source and set the decoder. You can also enable/disable the Video and Audio alarming system.
- Audio: Decoder audio configuration page.
- Video: Decoder video configuration page.
Output
On this page, you can select the input source for ASI1 and ASI2 Output interfaces.
BISS
On this page, you can select the input source from the available input list. The page also displays the corresponding BISS Programs list.
Mux
This page can be used for the Mux configuration. It also contains the Mux Programs list, where programs can be added to the multiplexer.
TS over IP
This page can be used for the TS over IP configuration, including the input source selection from the available input list, and stream configuration parameters.
The page contains page buttons that open the following subpages:
- DVB: Allows you to configure Uni/Multicast parameters, i.e., the IP address, UDP Port and MAC Address.
- IPTV: Allows you to configure the IPTV channels, including the Channel Status, IP address, UDP Port, Target MAC address, EIT and TDT/TOT. You can also check the lists of Programs that are running on each IPTV channel. However, it is not possible to edit these lists (i.e., to add or remove programs).
Backup
This page contains Backup configuration parameters.
System
This page contains page buttons that open the following subpages:
- Device: Contains device configuration parameters, e.g., Board Type, Mux Function, Backup Function, Reboot Command, Default settings, etc.
- Version: Displays the software version.
- Network: Allows you to configure the network parameters, e.g., Device IP, Subnet Mask, etc.
Traps
This page contains a table detailing the received traps.
Web Interface
This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.