Table of Contents

Itelsis Amplifier ATVD2 100W

This connector for the Itelsis Amplifier ATVD2 100W polls parameters of the device and captures traps. The parameters are displayed on several pages and the traps update the value of some standalone parameters, not corresponding to existing SNMP parameters.

About

This connector polls SNMP parameters of the Itelsis Amplifier ATVD2 100W with several timers (a slow, medium and fast timer). The traps are captured and update parameters on the Traps page. When the element restarts, the old values of those parameters are restored.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device, e.g., 178.60.199.10.
  • Device address: The port number of the web interface.

SNMP Settings:

  • Port number: Port number of the connected device, by default 161, e.g., 24161 or 25161.
  • Get community string: The community string used when reading values from the device. The default value is public.
  • Set community string: The community string used when setting values on the device. The default value is private.

Usage

The connector consists of 5 pages:

  • General page with general information about the device.
  • Configuration page.
  • Measures page divided in Power Measures, Current Measures and Power Supply Measures.
  • State page divided in Fans States, Power Alarms, Current Alarms and Power Supply Alarms.
  • Traps page displaying the received traps.
Improve this page