Table of Contents

Itelsis Exciter ATVD2 AGILE

This connector for the Itelsis Exciter ATVD2 AGILE polls parameters of the device and captures traps. The parameters are displayed on several pages. The traps are used to update the value of some standalone parameters.

About

This connector polls SNMP parameters of the Itelsis Exciter ATVD2 AGILE with several timers. The traps are captured and used to update parameters on the Traps page. When the element restarts, the old values of those parameters are restored.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device, e.g., 178.60.199.10.
  • Device address: The port number of the web interface.

SNMP Settings:

  • Port number: The port number of the connected device, by default 161, e.g., 24161 or 25161.
  • Get community string: The community string used when reading values from the device. The default value is public.
  • Set community string: The community string used when setting values on the device. The default value is private.

Usage

The connector consists of the following pages:

  • Home page: Displays general information about the device and allows you to reset the exciter and turn it on or off.
  • Traps page: Displays the received traps.
Improve this page