JVC PTZ Camcorder
JVC PTZ Camrecorder KY-PZ100 is a robotic pan, tilt and zoom video production camera, it can be used as a single camera or part of a multi-camera shoot. In addition to its 3G-SDI and HDMI outputs, it is also capable of reliably streaming 1080i/60, 1080p, 720p, and 360p video with 2-channel audio-all. The JVC PTZ Camrecorder connector can be used to display and configure information related to this device.
About
This connector allows you to access various information on the device. Data is retrieved using HTTP. There are different possibilities available for alarm monitoring and trending.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial Version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | V0102-0103 |
Installation and configuration
Creation
HTTP Main Connection
This connector uses a HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
Usage
General
In this page it is possible to set the Username and Password for retrieving the camera data. Also System** Model**, Destination and API version is available in this page.
Status
This page displays information related to the main camera operations:
- Pan/Tilt: Pan and Tilt parameters will move the camera with a configurable Speed.
- Zoom: Manual zoom can be configured using Zoom Position; or Tele and Wide buttons can be used as well for Zoom In and Zoom Out
- Focus: Can be set to Auto or manual using the Far and Near buttons.
- Streaming: Resolution and Bit Rate can be configured for streaming the image.
Camera
In this page it is possible to configure some camera settings depending on the Exposure Status value:
- If it is set to Auto, Automatic Exposure (AE) Level can be configured.
- If it is set to Shutter, AE Level and Shutter can be configured.
- If it is set to Iris, AE Level and Iris can be configured.
- If it is set to Manual, Iris, Gain and Shutter can be configured.
It is also possible to configure the White Balance. When it is set to AWB or Manual, Red and Blue values can be configured.
Server
In this page it is possible to configure the Live Streaming Server. When configuring the Server Settings, note that some parameters are mandatory to be filled in depending on the server Type:
- UDP: Address and Port must be filled in.
- Zixi: Address, Port, Stream ID, Password, Latency and Adaptive Bitrate must be filled in.
- RTP: Adddress, Port, SNMPTE 2022-1 FEC, FEC Matrix L and FEC Matrix R must be filled in.
- RTMP: URL and Stream Key must be filled in.
- RTSP: Password must be filled in.