Keysight U2040 X-Series
The Keysight U2040 X-Series is a device capable of executing power measurements over multiple measurement points. This connector can be used to monitor the power measurements collected by this device.
About
The U2040 X-Series wide dynamic range power sensors consist of four USB models and a LAN model:
- U2041XA USB wide dynamic range average power sensor (10 MHz to 6 GHz)
- U2042XA USB peak and average power sensor (10 MHz to 6 GHz)
- U2043XA USB wide dynamic range average power sensor (10 MHz to 18 GHz)
- U2044XA USB peak and average power sensor (10 MHz to 18 GHz)
- U2049XA LAN power sensor (10 MHz to 33 GHz, LXI Class C compliant)
The U2040 X-Series is capable of measuring the average and peak power of modulated, pulsed, and continuous wave (CW) signals in a 10 MHz to 33 GHz frequency range and -70 dBm to 26 dBm power range.
The U2049XA is capable of long-distance remote monitoring of up to 100 meters via the Power over Ethernet (PoE)/LAN connectivity. The PoE connectivity complies with the IEEE 3 W, 802.3af or 802.3at Type 1 standard.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | A.02.04 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
Usage
General
This page displays basic information on the device, such as the Vendor, Model, Serial Number and Firmware Version.
Measurements
On this page, you can reset all configuration on the device with the Presets button, set a frequency value for measurements and check the measurements in the Measurements Table.
The Value column in the Measurements Table supports Trending and Alarm monitoring.
Calibration
This page provides access to the calibration methods of the device such as Zero calibration, Calibration and Calibration + Zero. It also allows you to set the Auto Calibration State and the Zero Calibration Type.