Locus RCP-1100
This is a serial connector that will show the status of the different parameters of a Locus RCP-1100 device.
About
The Locus RCP-1100 consists of a SWO control panel, There is no web interface to control the device.
Configuration
Connections
The Locus RCP-1100 is a serial connector and requires the following input during element creation:
Serial CONNECTION:
- Type of port: TCP/IP
- IP address: The IP of the device (e.g., 10.11.12.13)
- IP Port: The IP Port of the device (8080)
Usage
General Page
This contains some general configuration information about the the device such as:
- Power supply status
- Amplifiers Status
- Amplifiers Power
Switch Configuration Page
This contains information about the pins of the 3 switches.
Fault Status Page
This contains information about the Fault Status of the device such as:
- Amplifiers faults
- Power supply Faults
- RF Switch Faults
- ...
Configuration Page
This page contains parameters to configure the Remote Input Switch and the Auto Broadcast State