MCL MT3200 SABus
The MT3200 is a medium power satellite amplifier designed for both mobile and earth station based applications.
The MCL MT3200 SABus connector is used to monitor MT3200 devices that use the SABus protocol.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device.
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
How to use
On the General page, the RF Digital Attenuator will initially be set to Not Initialized since it only has a write command. After a new value has been set, the parameter will display the new value if the set was successful.
On the Analog Status page, the Gain Percentage parameter can be used to adjust (increase or decrease) the Gain of the HPA. When this parameter is changed, the Gain will also change proportionally. For example, if the Gain Percentage is changed from 20% to 25%, the Gain will increase by 5.