MDOUK STL-IP-16

With this connector, information can be gathered and viewed from the device MDOUK SLT-IP-16. The connector also allows the user to perform sets on the device.

About

This connector is used to gather information from the MDOUK SLT-IP-16 device.

The connector has several pages with general information, network status, audio, etc.

Installation and configuration

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP Connection:

• IP address/host: The polling IP of the device, e.g., 10.22.4.11.
• Device address: Not needed.

SNMP Setting:

• Port number: The port of the connected device, by default 161
• Get community string: The community string in order to read from the device. The default value is public.
• Set community string: The community string in order to set to the device. The default value is private.

Usage

General

This page displays general information regarding the device, such as the system temperature, power supply status, system and case fan status, etc.

Network Status

This page shows the network status of the device.

The page also includes a page button, Jitter Buffer. On this subpage, the user can find information regarding the device jitter buffer channels.

Tx Status

This page displays the status of the Tx channels of the device.

Rx Status

This page displays the status of the Rx channels of the device

Audio

This page displays the audio status of the device. It also allows the user to reset the following:

• Audio Overload
• Audio In Silent Detect
• Audio Out Silent Detect