Table of Contents

MIT-xperts iAnalyzer EIT

This connector has been designed to monitor the MIT-xperts iAnalyzer EIT with SNMP.

About

This device decodes and displays one or more input MPTS/SPTS, and especially analyzes the EIT/EPG data for potential problems and errors (overlapping events, incorrect packaging, timing issues, etc.).

Installation and creation

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device, e.g., 10.11.12.13.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string in order to read from the device. The default value is public.
  • Set community string: The community string in order to set to the device. The default value is private.

Usage

General page

The General page gives an overview of the state of the iAnalyzer.

Services page

The Services page displays the Service Table and it has a page button to the Service Faults page for a more detailed overview of the service fault states.

Webpage

The webpage of the device.

Improve this page