Table of Contents

Mandozzi DT99

With this connector, information can be gathered and viewed from the combimux Mandozzi DT99. The connector also makes it possible to set values on the device.

About

This connector uses SNMP to interface with the Mandozzi DT99 combimux.

Installation and configuration

Creation

SNMP main connection

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP Address/host: The polling IP of the device.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string in order to read from the device. The default value is public.
  • Set community string: The community string in order to set to the device. The default value is private.

Usage

General Page

This page displays general parameters for the device, such as the System Name, System Description and SNMP Agent Version Number.

This page also displays two buttons:

  • Trap Configuration: Opens the trap configuration page.
  • Reset Device: Resets the combimux.

Trap Configuration Page

This page displays parameters related to the Trap Configuration:

  • Trap Alarms Destination Address
  • M1 CCPU Alarm Status Trap
  • M2 CCPU Alarm Status Trap
  • M3 CCPU Alarm Status Trap
  • M4 CCPU Alarm Status Trap
  • M5 CCPU Alarm Status Trap
  • M6 CCPU Alarm Status Trap
  • M7 CCPU Alarm Status Trap
  • M8 CCPU Alarm Status Trap

The page also allows you to set a new Trap Alarms Destination Address and to toggle the Alarm Status Traps between enabled and disabled for each CCPU.

Combimux Page

This page displays the CCPU alarm status parameters of the device:

  • M1 CCPU Alarm Status
  • M2 CCPU Alarm Status
  • M3 CCPU Alarm Status
  • M4 CCPU Alarm Status
  • M5 CCPU Alarm Status
  • M6 CCPU Alarm Status
  • M7 CCPU Alarm Status
  • M8 CCPU Alarm Status
Improve this page