MegaTec NetAgent9
This connector is used to monitor the NetAgent9 UPS management device, which allows configuration via web browser, NMS, Telnet, or SNMP. The NetAgent9 supports the MegaTec single- and three-phase UPS protocols.
About
Version Info
| Range | Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 3.8.CY504 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection
This connector uses a Simple Network Management Protocol (SNMPv2) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element mainly displays SNMP parameters as defined in the device MIB.
The Alarms page contains an Alarms table that displays SNMP traps forwarded by the connected device. You can delete alarms via the right-click menu of the table. On the Alarm Settings page, you can also configure a fixed lifetime for the alarms, after which they are automatically cleared by the connector.