Meinberg Lantime M3000 - PTPv2 Module

This is a DVE connector that is exported by the Meinberg Lantime M3000 connector.

About

This SNMP connector is used to monitor and configure the Meinberg Lantime M3000.

Version Info

Range	Key Features	Based on	System Impact
1.0.0.x [SLC Main]	Initial version	-	-

Configuration

The element using this connector is automatically generated by the parent connector Meinberg Lantime M3000.

Initialization

No extra configuration is needed.

Redundancy

There is no redundancy defined.

How to use

A DVE child element is created for each row in the PTP table unless the port status for that particular module is either Disabled or Deleted. All columns from the element running the Meinberg Lantime M3000 connector are exported as single parameters to the subpage corresponding with the table name (e.g., the columns from the Basic Networking table in the parent connector are exported to the Basic Networking page in the child element).

DCF connections are exported to the child element as a physical dynamic interface.