Table of Contents

Meinberg SCU-XPT

The Meinberg SCU-XPT connector is an SNMP connector that is used to monitor Meinberg SCU-XPT devices with SNMP.

About

With this connector, you can monitor the status of satellite tracking with the Meinberg SCU-XPT.

Installation and configuration

Creation

SNMP Connection:

  • IP Address/host: The polling IP of the device.

SNMP Settings:

  • Port number: The port of the connection device, by default 161.
  • Get community string: The community string required to read from the device. The default value is public.
  • Set community string: The community string required to set to the device. The default value is rwpublic.

Usage

General Page

This page contains general device statuses and information like: Master Select, SCU Type, PSU Status, etc.

GPS Refclock Page

This page displays information about the two refclocks, such as the Type, Mode, State, etc.

Improve this page