Mitec 18202-01MD Power Switching Controller
This connector displays status and summary information of the Mitec 18202-01MD Power Switching Controller. It also allows the user to execute remote commands to change the configuration of the device.
The Mitec 18202-01MD Power Switching Controller can monitor and control 4 RF Switches.
About
Serial commands are used to retrieve the device information and to execute the settings.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | Software version 01 Model Number 18202 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: 9600
- Databits: 7
- Stopbits: 1
- Parity: even
- FlowControl: no
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device. This is required. The default value is 14 (8013).
- Bus address: The bus address of the device. This is required. The default value is 31 (hex).
Usage
General
This page displays the Model Number.
Status
This page displays the Local/Remote Mode, Switch Summary and Power Supply Summary, and finally also the Switch 1, Switch 2, Switch 3, and Switch 4 settings.
The Switch 1, Switch 2, Switch 3 and Switch 4 can be configured by clicking the toggle button under each position.
There are two possible positions for each switch: Position 1 and Position 2.