Table of Contents

Mitec ALGA

About

This connector is used to monitor and configure a Mitec ALGA device.

Configuration

Connections

SNMP Connection

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device.

SNMP Settings:

  • Port number: The port of the connected device, by default 161
  • Get community string: The community string used when reading values from the device. By default public.
  • Set community string: The community string used when setting values on the device. By default private.

Web Interface

The web interface is only accessible when the client machine has network access to the product.

How to use

These are the main data pages of the connector:

  • The General page provides general information about the device.

  • On the Control page, you can adjust the mute and gain settings for BUCs.

  • Information about HPA units is available on the Status page.

  • Alarm logs are available on the Alarm Log page.

Note

Read and write parameters for the KPIs on the Control page are handled separately. To ensure accuracy, the read parameter is updated immediately after the write parameter is set, and a retry mechanism has been implemented.

Improve this page