Mitec WTX - 5964xx-70-ES-xx
The Mitec WTX-5964xx-70-ES-xx connector can be used to read information from the High Power Transmitter Unit and to configure its settings. The communication between the protocol and the device is established using a serial connection.
About
Using serial communication, the protocol retrieves settings, telemetry, and alarm information from the unit. Some of these parameters are: Temperature, L-Band Frequency (also called IF Frequency), Output Power, and Mute Status. The protocol also sets some of the parameters on the Mitec WTX-5964xx-70-ES-xx, for example the Device Address and IF Frequency.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 3900040-00-Rxx |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | Yes | Yes | - | - |
Installation and configuration
Creation
Serial main connection
This protocol uses serial communication to transmit commands and receive responses from the target devices. It requires the following input during element creation:
SERIAL CONNECTION
- IP Address/Host: The polling IP of the device, e.g., 10.255.110.xx.
- IP port: The device port location at the specified IP, e.g., 10.255.110.xx:15000.
Usage
Main View
This page displays general information about the Mitec WTX-5964xx-70-ES-xx, organized into read-only parameters on the one hand and read-write parameters on the other hand. These are:
- Booster Read-Only Parameters: Software Version, Temperature [deg C], Sensor Voltage Temperature [deg C], Output Power [dBm], Gain [dB].
- Booster Read-Write Parameters: Mute Status, IF Frequency, Device Address.
Booster Alarm
This page displays the three alarms that can be rendered by a device using this software version. These are:
- System Alarms: Over Temperature Alarm, Low Power Alarm, Summary Alarm.
DataMiner Connectivity Framework
The Mitec WTX-5964xx-70-ES-xx connector supports the usage of DCF.
DCF can also be implemented through the DataMiner DCF user interface and through DataMiner third-party connectors (for instance a manager).
Connections
Internal Connections
Between input and output an internal connection is created with the following properties:
input connection property of type in.
- output connection property of type out.