Miteq DNB1-XTR
This connector allows monitoring and control of the downconverter. The connector is compatible with the Miteq DNB1 and DNB2 models.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | This range uses SNMP communication. | - | - |
| 1.0.1.x | This range uses serial communication. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | D163995V2.121.25 |
| 1.0.1.x | D163995V2.121.25 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 1.0.1.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection — Main — 1.0.0.x only
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Serial Connection — Main — 1.0.1.x only
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device. Range: 64 - 95 (ASCII character "@" to "_").
Initialization
No extra configuration is needed.
Redundancy
There is no redundancy defined.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
No special actions are required to use this connector.