Miteq LN2-177220-120
The Miteq LN2-177220-120 is a 1:2 redundant low-noise amplifier system designed to ensure continuous operation without disruption of signal transmission. A fault condition in the online LNA or an operator-generated command will switch the standby LNA to the online position and remove the online LNA from the signal path. The redundant LNA system consists of an outdoor amplifier/switch assembly that mounts at the antenna hub, a rack-mounted indoor local control unit and an interconnection control cable.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | Unknown (Manual version used was 11/19/14: REV.A Initial Release) |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION (via Serial Gateway):
Interface connection:
- IP address/host: The polling IP of the device, e.g., 127.0.0.1.
- IP port: The IP port of the device, e.g., 4004. Required.
- Bus address: The bus address of the device, e.g., 64. Required.
Initialization
The connector does not require credentials, so setting it up is rather straightforward.
Redundancy
No redundancy is defined in the connector.
Web Interface
No web interface page is defined in the connector.
How to Use
You can find all the information you need to monitor on the General data page.
On the Control Unit page, you can control the device, e.g., use the Online/Standby LNA and the Redundancy Mode.