Miteq RSU-B
This connector uses serial communication to allow monitoring of the Miteq RSU-B.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version. | - | - |
| 1.1.0.x [SLC Main] | On these devices, the response starts by repeating the original command, followed by the normal response. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
| 1.1.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | Yes | Yes | - | - |
| 1.1.0.x | Yes | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- Direct connection:
- Baudrate: Baudrate specified in the manual of the device.
- Databits: Databits specified in the manual of the device.
- Stopbits: Stopbits specified in the manual of the device.
- Parity: Parity specified in the manual of the device (possible values: even, odd).
- FlowControl: FlowControl specified in the manual of the device.
- Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device (range: 95 - 64).
Usage
On the General page of the element, you can find the following information:
- Unit A: Fault status of converter unit A.
- Unit B: Fault status of converter unit B.
- Status: Indicates which of the two available inputs is connected to the output.
DataMiner Connectivity Framework
The 1.0.0.x connector range of the connector supports the usage of DCF.
DCF can also be implemented through the DataMiner DCF user interface and through DataMiner third-party connectors (for instance a manager).