Miteq UPC2
This Uplink Power Control (UPC) is designed to adjust the strength of uplink signals to compensate for varying weather conditions in order to ensure that a stable signal strength is received by the satellite.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | v1.15 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (default: 161).
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
This connector contains the following pages:
- General
- System Status
- Configuration
- Channel Setup
On the General page, you can find general information about the device, such as the Firmware Version, UPC Control Mode, etc. More system status information is located on the System Status page.
On the Configuration page, certain parameters can be configured. You can change the active receiver to A or B, change the Correction Algorithm, etc.