Motorola GX2-CM100 B - GX2-CM100B-R
The Motorola GX2-CM100 B - GX2-CM100B-R connector is an SNMP-based connector used to monitor and configure the Motorola GX2-CM100B-R.
About
This connector provides a monitoring interface for the Motorola GX2-CM100B-R module.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 2.0.1.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 2.0.1.x | P |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 2.0.1.x | No | Yes | - | - |
Installation and configuration
Creation
This connector is used by DVE child elements that are automatically created by the parent connector Motorola GX2-CM100 B, from version 2.0.1.1 onwards.
Usage
General
This page displays general information about the card, including the Unit Name, Module Type, Firmware and Hardware Version, IP Address and Physical Address.
The page also contains two page buttons:
- Downloads: Displays the parameters Downloaded Slots, Auto Download Reset, Download Filename, Switch Firmware Bank and Download State.
- Security: Displays the parameters Mode, Factory Password, Operator Password, Read Only Password, Remote Only Password, Local Only Password.
Controller
This page displays the current Temperature, the Digital Mode, the Digital Reset Slot, the Shelf Identifier and the Reset Alarm parameter.
Alarms
This page contains all Status parameters.
AMC
This page displays the Controller AMC Table and the parameter Auto Quick Swap Interval.
Diagnostic
This page displays the parameters LED Test Pattern, Fan Test Mode, Relay Test Mode, Relay Control, Slot Poll Mode, Boot Count, Object Table Data, Reset System Time, Alarm Slot and Controller Diagnostic Table. The latter contains a column that allows you to reset both the success and the failure values.
Factory
This page displays CRC Parameters, Flash Banks and Flash Counters.
Network
This page contains all the parameters related to IP addresses, the TFTP Server and the Shelf Serial Number.
It includes two page buttons:
- ISDN: Displays the Mode, Modem IP Address, Trap Timeout, Ping Timeout and Backoff Timer.
- Traps: Displays the Trap Destination IP Addresses.
Traps History
This page displays both the Trap History and the Trap Receiver table.
Web Interface
This page displays the webpage of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.