Motorola GX2-RX200BX4
The Motorola GX2-RX200BX4 connector is an SNMP-based connector used to monitor and configure the Motorola GX2-RX200BX4.
About
This connector provides a monitoring interface for the Motorola GX2-RX200BX4 chassis.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | No |
| 2.0.0.x | DVE focused | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
| 2.0.0.x | B |
Usage
General
This page displays general information about the card. Unit Name, Module Type, Firmware and Hardware version, IP Address and Physical Address are some of the parameters that can be found here.
Optical Receiver
This page displays the Optical Power 1, 2, 3, and 4, Fan Current, Analog 12V Current, Digital Revert Time, Module Configuration, Digital Test Point and Default Reset.
It also contains a page button, Settings, which displays a table where you can configure all the digital parameters: Mode, Wavelength, Attenuation and Switch Threshold.
Alarms
This page contains all the Status parameters.
Factory
This page displays CRC Parameters, Flash Banks and Flash Counters.
Web Interface
This page displays the webpage of the device.
Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.