Moxa CN2600 Series
This device has the ability to enable redundancy in your network.
This connector allows you to retrieve information from the Moxa CN2600 series. It allows you to monitor alarms and statistical information, and configure/activate the entire device.
The connector retrieves and sets information on the device through SNMP.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
- Device address: Not required.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: : The community string used when setting values from the device, by default private.
Usage
General
The general page contains generic machine information/configuration. Moxa Overview: This gives you an overview of the moxa general condition and settings such as Model name, firmware, serial number, power connection, etc.
Interface Info
Allows you to monitor the interface values as well as bit rates on the different ports of the moxa device.
Monitor Remote IP
Allows to monitor the connected IP addresses.
Monitor Serial Port
This page includes:
- Serial Port Status
- Serial Port Error Count
- Serial Port Buffering
There is also a Settings Page, which is only for monitoring purposes.
System Management
This page includes the following settings:
- SNMP Settings
- Server Settings
- Time Settings
- Host table
- Route table
- User Settings
- Authentication Server
- System Log Settings
- Console Settings
- Accessible IP List
- DDNS Agent
- Save And Restart Settings
- Reset to Factory default
- Auto warning Settings
Network settings
Configuration of:
- LAN 1
- LAN2
- LAN PPPoE Account
- DNS Settings
- Wins Settings
- ARP Settings
Serial Port Settings
All port settings:
Application:
- Sockets
- Data Packing
- Device Control
- Reverse Terminal
- Terminal
- DRDAS
- Dial
Welcome Message
Redundant COM
Communication Parameter
Data Buffering/logging
Modem Settings
Port Mode
Web interface
Allows you to access the web interface of the device.