NTP RCP
The NTP RCP connector is used to control/monitor a router control device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: 9600 (specified in the device manual).
- Databits: 8 (specified in the device manual).
- Stopbits: 1 (specified in the device manual).
- Parity: No (specified in the device manual).
- FlowControl: No (specified in the device manual).
Interface connection:
- IP address/host: The IP address of the device.
- IP port: The IP port of the device.
How to use
The General page shows basic information about the device such as Version, Number of Users, Matrices, Macros, Virtual GPIs, Levels, Sources, and Destinations. It also includes a Refresh button, which refreshes the matrix information. With the Park Input parameter you can configure to which input an output should be connected when a crosspoint is disconnected.
The Logical Lines page contains Sources and Destinations tables.