NTT Electronics HVE9230
The NTT ELECTRONICS HVE9230 is enhanced AVC/H.264 encoder which provides advanced features of 16 channels audio for 8 stereo, 5.1 ch. + stereo, or 8 PES transmission. Ancillary Data transmission or High Efficiency Video Mode in addition to the features available on HVE9200. HVE9230 also provides One Frame Super Low Latency for high quality video transmission, Closed Captioning for IPTV or CATV AVC/H.264 transmissions.
About
Using this connector, is possible to monitor the hardware and performance status of HVE9230 . It is also possible to change configuration on writable parameters. This connector uses a SNMP connection to retrieve data from this device and to set parameters on it.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 07.00 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string in order to read from the device. The default value is public.
- Set community string: The community string in order to set to the device. The default value is private.
Usage
General Page
This page displays general device information (Description, Version, System Uptime).
There is a Reset button that can be used to perform a system-wide reset.
Page Buttons:
- Memory
- NTP
- Test Signal
Device Status Page
This page contains general information about the status of the device. Examples are Device services, Temperature and Fan Status.
Alarms Page
This page displays the alarms reported by the device in a table format.
Transport Stream Page
This page displays The format select of the Stream transmission, i.e Channel 1 Packet Type.
Video Page
This page displays information related to the Video Format. Examples are Video Aspect, Latency Mode and Entropy.
Audio Page
On this page can view the general information about Audio, such as Audio Gain Level and Audio Map.
Page Buttons:
- Settings
- Audio Gain Level
- Audio Map Mode
Ancillary
This page contains information about the Encoder Ancillary.
Status ID
On this page can view the general information about PID, such as Audio Packet ID and Video ID.
Page Buttons:
- Audio ID
IO Page
This page displays information about Output service.
Page Buttons:
- PSI
- BISS
IP Page
This page contains IP parameters. Examples are IP Address, IP FEC and Encryption of the channel.
Device Settings
This page displays information about Encoder Settings.
Page Buttons:
- Param Select
Network
On the Network page you are able to view and configure the Control and Data.
Page Buttons:
- Settings
Web Interface Page
This page shows the device's web interface through DataMiner.
Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.