Nagra Merlin

The Nagra Merlin is a conditional access system.

About

This connector uses SNMP to monitor the Nagra Merlin device. The retrieved information is displayed on different pages.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP of the device.

SNMP Settings:

• Port number: The port number of the device, by default 161.
• Get community string: The community string used when reading values from the device. The default value is public.
• Set community string: The community string used when setting values on the device. The default value is private.

Usage

You can find more information on the Main Page and General Page below. The connector contains a number of other pages, on which you can find a large number of individual alarm parameters. All parameters can be monitored and trended.

Main Page

This page contains overall important alarms such as Application Failure, Disk Full, Low Free Disk Space, etc.

General Page

On this page, you can view the Alarm Table of the device. However, you must load the table manually using the Load button.