Netgear FS726T

The FS726T is a Netgear PROSAFET 24 PORT 10/100 Smart Switch with 2 Gigabit Ports.

About

This connector is intended to communicate with the device using SNMP commands.

Installation and configuration

Creation

SNMP CONNECTION:

- IP address/host: The polling IP of the device, e.g., 10.11.12.13

- Device address: not used

SNMP Settings:

- Port number: the port of the connected device, default 161

- Get community string: the community string in order to read from the device. The default value is public.

- Set community string: the community string in order to set to the device. The default value is private.

Usage

General

Use this page to have access to general system information.

Interfaces

Here it's available the Interface Details table where is possible to have information about the 24 10/100 Mbps and the 2 Gigabit Ports. The only parameter available to set is the Admin State.

Web Interface

To have access to the device's configuration webpage.