Nevion Flashlink Frame - 3G-HD-OE-2-L

This exported connector shows data from a 3G-HD-OE-2-L module in a Nevion Flashlink frame.

About

This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.

Version Info

Range	Description	DCF Integration	Cassandra Compliant
1.0.0.x	Basic range	No	Yes
2.0.0.x	Tree controls added to monitor parameters	No	Yes
2.0.1.x	Audio Block status fix (ONLY for firmware 2.0.4)	No	Yes
2.0.2.x	Changed naming structure	No	Yes

Product Info

Range	Supported Firmware Version
1.0.0.x	Unknown
2.0.0.x	Unknown
2.0.1.x	5.0.4
2.0.2.x	5.0.4

Installation and configuration

Creation

This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.

Usage

General Page

This page contains general information about a 3G-HD-OE-2-L module, including:

Type
Card Status
Chassis Number
Slot Number
Label
Alarm Status
Alarm Trap
Alarm Count
Main Element Name
Active Alarms in System

Voltage Page

This page displays the Voltage Table, which contains information about voltage measurements.

It also allows you to configure the Mode, Current Input, Main, Backups, Rule, Latch, Hold and Lock Time and Alarms.

Optical Input Page

This page displays the Optical Input table, which contains information about optical input parameters.

It also allows you to view the Opt Input, Input Status and Signal Strength, as well as to configure the Opt Input Alarms.

Reclocker Page

This page displays the Reclocker Table, which contains information about reclocker parameters.

It also allows you to view the Reclocker Num, Status and Bit Rate, as well as to configure Config, ASI, Bandwidth and Alarms.

GPIO Page

This page displays the General Purpose Input Output Table, which contains information regarding I/O blocks.

It also allows you to configure the Mode, Status, Description and Alarms.

Changeover Page

This page displays the Changeover Table, which contains information about cho1BlockTable parameters.