Nevion Flashlink Frame - 3G-IP-MUX-8-SFP
This exported connector shows data from an 3G-IP-MUX-8-SFP module in a Nevion Flashlink frame.
This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.
About
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 2.0.3.x | Added "card location" and "label" to description column (for all tables). | No | Yes |
Product Info
| Range | Supported Firmware |
|---|---|
| 2.0.3.x | 5.0.4 |
Configuration
This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.
Usage
General Page
This page contains general information about a 3G-IP-MUX-8-SFP module, including:
- Type
- Card Status
- Chassis Number
- Slot Number
- Label
- Alarm Status
- Alarm Trap
- Alarm Count
- Main Element Name
- Active Alarms in System
Alarms Page
This page displays the Alarms Table.
Audio Page
This page displays the Audio Block Table, which contains information about all audio I/O blocks.
It also allows you to configure certain parameters, such as Incoming and Outcoming Format, SRC, Peak and Max Level, Alarms, etc.
Delay Page
This page displays the Delay Table, which contains information about delay parameters.
You can also configure the Status, Lines, Samples, and Nanosecs delays.
GPIO Page
This page displays the General Purpose Input Output Table, which contains information regarding I/O blocks.
It also allows you to configure the Mode, Status, Description, and Alarms.
Laser Page
This page displays the Laser Table, which contains information about laser parameters.
It also allows you to view the Laser Num, Wavelength, Power, and Type, as well as to configure the Config, Status and Alarms.
Optical Input Page
This page displays the Optical Input table, which contains information about optical input parameters.
It also allows you to view the Opt Input, Input Status, and Signal Strength, as well as to configure the Opt Input Alarms.
Sync Source
This page displays the Sync Source Table, which lists all sync source inputs.
It also allows you to view the Sync Src, Type, Lines, Frame Rate, and Structure, Sample Rate and Word Length, as well as to configure Alarms.
Signal Integrity Page
This page displays the Monitor Table, which contains information about monitor parameters.
It also allows you to configure Monitor Alarm, Error Count, Error Delta and Error Free Alarm, FF-CRC, AP-CRC, LOCK, ANCS, etc.
Temperature
This page displays the Temperature Table, which contains information about temperature measurements.
It also allows you to configure the Nominal value, Upper and Lower Limit and Alarms, as well as to view the actual temperature Value.
Video Generator
This page displays the Video Generator Table, which lists all video generators.
It also allows you to configure the Pattern, Y, Cb and Cr.
Voltage Page
This page displays the Voltage Table, which contains information about voltage measurements.
It also allows you to configure the Upper and Lower Limit and Alarms, as well as to view the Nominal effect and the Value in Volts and Watts.