Nevion Flashlink Frame - 3GHD-EO-SFP
This exported connector shows data from a 3GHD-EO-SFP module in a Nevion Flashlink frame. This module is a single or dual multi bit-rate electrical to optical converter, providing high-performance media conversion for various signal formats from 19.4 Mbps up to 2970 Mbps.
About
Product Info
| Range | Supported Firmware |
|---|---|
| 2.0.3.x | 5.0.4 |
Configuration
This SNMP connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.
How to use
The element created using this connector consists of the data pages detailed below.
General
This page contains general information about the module, including:
- Type
- Card Status
- Chassis Number
- Slot Number
- Label
- Alarm Status
- Alarm Trap
- Alarm Count
- Main Element Name
- Active Alarms in System
Laser
This page displays the Laser Table, which contains information about laser parameters.
GPIO
This page displays the General Purpose Input Output Table, which contains information regarding I/O blocks.
It also allows you to configure the Mode, Status, Description and Alarms.
Signal Input
This page displays the EQ Table, which contains information about EQ parameters.
It also allows you to view the Num and Status, as well as to configure Config and Alarms.
Reclocker
This page displays the Reclocker Table, which contains information about reclocker parameters.
It also allows you to view the Reclocker Num, Status and Bit Rate, as well as to configure Config, ASI, Bandwidth and Alarms.
Temperature
This page displays the Temperature Table, which contains information about temperature measurements.
It also allows you to configure the Nominal value, Upper and Lower Limit and Alarms, as well as to view the actual temperature Value.
Voltage
This page displays the Voltage Table, which contains information about voltage measurements.
It also allows you to configure the Upper and Lower Limit and Alarms, as well as to view the Nominal effect and the Value in volt and watt.