Nevion Flashlink Frame - AAV-HD-XMUX
This exported connector shows data from an AAV-HD-XMUX module in a Nevion Flashlink frame.
About
This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Basic range | No | Yes |
| 2.0.0.x | Tree controls added to monitor parameters | No | Yes |
| 2.0.1.x | Audio Block status fix (ONLY for firmware 2.0.4) | No | Yes |
| 2.0.2.x | Changed naming structure | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 2.0.1.x | 5.0.4 |
| 2.0.2.x | 5.0.4 |
Installation and configuration
Creation
This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.
Usage
General Page
This page contains general information about an SDI-OE-S module, including:
- Type
- Card Status
- Chassis Number
- Slot Number
- Label
- Alarm Status
- Alarm Trap
- Alarm Count
- Main Element Name
- Active Alarms in System
Audio
This page displays the Audio Block Table, which contains information about all audio I/O blocks.
It also allows you to configure some parameters, such as Incoming and Outcoming Format, SRC, Peak and Max Level, Alarms, etc.
Audio Generator
This page displays the Audio Generator Table, which contains information about audio generators.
Audio Processing - Embedder
This page displays the Audio Proc Table, which contains information about the audio processing capabilities of each card. The table allows you to configure the Mode and view the Audio Proc, Inputs and Outputs.
This page also displays the Embedder Table, which lists all embedders for those modules that have them. This table allows you to configure the Status, Word Length and Alarms, as well as to enable or disable the embedder.
Delay
This page displays the Delay Table, which contains information about delay parameters.
It also allows you to configure the Status, Lines, Samples and Nanosecs delays.
Changeover
This page displays the Changeover Table, which contains information about cho1BlockTable parameters.
It also allows you to configure the Mode, Current Input, Main, Backups, Rule, Latch, Hold and Lock Time and Alarms.
GPIO
This page displays the General Purpose Input Output Table, which contains information regarding I/O blocks.
It also allows you to configure the Mode, Status, Description and Alarms.
Cable Driver
This page displays the Cable Driver Table, which contains information about cable driver parameters.
It also allows you to configure the Config and Slew Rate.
Signal Integrity
This page displays the Monitor Table, which contains information about monitor parameters.
It also allows you to configure Monitor Alarm, Error Count, Error Delta and Error Free Alarm, FF-CRC, AP-CRC, LOCK, ANCS, etc.
Serial Port
This page displays the Serial Port Table, which contains all serial port functions, such as Mode, Status, Parity, Stopbits, Speed, etc.
Laser
This page displays the Laser Table, which contains information about laser parameters.
Voltage
This page displays the Voltage Table, which contains information about voltage measurements.
It also allows you to configure the Upper and Lower Limit and Alarms, as well as to view the Nominal effect and the Value in volt and watt.
Video Generator
This page displays the Video Generator Table, which lists all video generators.
It also allows you to configure the Pattern, Y, Cb and Cr.
XMUX Matrix
This page displays the XMUX Matrix Table, which represents the matrix shown on the web interface of the AV-SD-XMUX or AVV-SD-XMUX device.
It also allows you to configure the Input and Crosspoint Lock.