Table of Contents

Nevion Flashlink Frame - AAV-SD-DMUX

This exported connector shows data from an AAV-SD-DMUX module in a Nevion Flashlink frame.

About

This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.

Version Info

Range Description DCF Integration Cassandra Compliant
2.0.3.x Basic range. No Yes

Product Info

Range Supported Firmware Version
2.0.3.x 5.0.4

Installation and configuration

Creation

This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.

Usage

General Page

This page contains general information about an AAV-SD-DMUX module, including:

  • Type
  • Card Status
  • Chassis Number
  • Slot Number
  • Label
  • Alarm Status
  • Alarm Trap
  • Alarm Count
  • Main Element Name
  • Active Alarms in System

Audio Page

This page displays the Audio Block Table, which contains information about all audio I/O blocks.

It also allows you to configure some parameters, such as Incoming and Outcoming Format, SRC, Peak and Max Level, Alarms, etc.

Audio Generator Page

This page displays the Audio Generator Table, which contains information about audio generators.

It also allows you to configure the Audio Level and view the Audio Generators.

Audio Processing - Embedder Page

This page displays the Audio Proc Table, which contains information about the audio processing capabilities of each card. You can configure the Mode and view the Audio Proc, Inputs and Outputs.

This page also displays the Embedder Table, which lists all embedders for those modules that have them. You can configure the Status, Word Length, and Alarms, as well as enable or disable the Embedder.

DMUX Matrix

This page displays the DMUX Matrix Table, which represents the matrix shown on the web interface of the AAV-SD-DMUX device.

It also allows you to configure the Input and Crosspoint Lock.

Cable Driver Page

This page displays the Cable Driver Table, which contains information about cable parameters.

It also allows you to configure the Config and Slew Rate.

Changeover Page

This page displays the Changeover Table, which contains information about cho1BlockTable parameters.

It also allows you to configure the Mode, Current Input, Main, Backups, Rule, Latch, Hold and Lock Time, and Alarms.

Delay Page

This page displays the Delay Table, which contains information about delay parameters.

It also allows you to configure the Status, Lines, Samples and Nanosecs delays.

Optical Input Page

This page displays the Optical Input Table, which contains information about optical input parameters.

It also allows you to view the Opt Input, Input Status and Signal Strength, as well as to configure the Opt Input Alarms.

Serial Port Page

This page displays the Serial Port Table, which contains all serial port functions, such as Mode, Status, Parity, Stopbits, Speed, etc.

Signal Integrity Page

This page displays the Monitor Table, which contains information about monitor parameters.

It also allows you to configure Monitor Alarm, Error Count, Error Delta and Error Free Alarm, FF-CRC, AP-CRC, LOCK, ANCS, etc.

Video Generator Page

This page displays the Video Generator Table, which contains information about all video generators.

It also allows you to configure the Pattern, Y, Cb and Cr.

Voltage Page

This page displays the Voltage Table, which contains information about voltage measurements.

It also allows you to configure the Upper and Lower Limit and Alarms, as well as to view the Nominal effect and the Value in Volts and Watts.