Nevion Flashlink Frame - AAV-SD-XMUX
This exported connector shows data from an AAV-SD-XMUX module in a Nevion Flashlink frame.
About
This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 2.0.3.x | Basic range. | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 2.0.3.x | 5.0.4 |
Installation and configuration
Creation
This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.
Usage
General Page
This page contains general information about an AAV-SD-XMUX module, including:
- Type
- Card Status
- Chassis Number
- Slot Number
- Label
- Alarm Status
- Alarm Trap
- Alarm Count
- Main Element Name
- Active Alarms in System
Audio Page
This page displays the Audio Block Table, which contains information about all audio I/O blocks.
It also allows you to configure certain parameters, such as Incoming and Outcoming Format, SRC, Peak and Max Level, Alarms, etc.
Audio Generator Page
This page displays the Audio Generator Table, which contains information about audio generators.
It also allows you to configure the Audio Level and view the Audio Generators.
Audio Processing - Embedder Page
This page displays the Audio Proc Table, which contains information about the audio processing capabilities of each card. You can configure the Mode and view the Audio Proc, Inputs and Outputs.
This page also displays the Embedder Table, which lists all embedders for those modules that have them. You can configure the Status, Word Length, and Alarms, as well as enable or disable the Embedder.
Cable Driver Page
This page displays the Cable Driver Table, which contains information about cable parameters.
It also allows you to configure the Config and Slew Rate.
Changeover Page
This page displays the Changeover Table, which contains information about cho1BlockTable parameters.
It also allows you to configure the Mode, Current Input, Main, Backups, Rule, Latch, Hold and Lock Time, and Alarms.
Delay Page
This page displays the Delay Table, which contains information about delay parameters.
It also allows you to configure the Status, Lines, Samples and Nanosecs delays.
Laser Page
This page displays the Laser Table, which contains information about laser parameters.
It also allows you to view the Laser Num, Wavelength, Power and Type, as well as to configure the Config, Status and Alarms.
Serial Port Page
This page displays the Serial Port Table, which contains all serial port functions, such as Mode, Status, Parity, Stopbits, Speed, etc.
Signal Integrity Page
This page displays the Monitor Table, which contains information about monitor parameters.
It also allows you to configure Monitor Alarm, Error Count, Error Delta and Error Free Alarm, FF-CRC, AP-CRC, LOCK, ANCS, etc.
Video Generator Page
This page displays the Video Generator Table, which contains information about all video generators.
It also allows you to configure the Pattern, Y, Cb and Cr.
Voltage Page
This page displays the Voltage Table, which contains information about voltage measurements.
It also allows you to configure the Upper and Lower Limit and Alarms, as well as to view the Nominal effect and the Value in Volts and Watts.
XMUX Matrix Page
This page displays the XMUX Matrix Table, which represents the matrix shown on the web interface of the AVV-SD-XMUX device.
It also allows you to configure the Input and Crosspoint Lock.