Nevion Flashlink Frame - AV-MUX
This exported connector shows data from an AV-MUX module in a Nevion Flashlink frame.
About
This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 2.0.3.x | Basic range. | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 2.0.3.x | 5.0.4 |
Installation and configuration
Creation
This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.
Usage
General Page
This page contains general information about an AV-MUX module, including:
- Type
- Card Status
- Chassis Number
- Slot Number
- Label
- Alarm Status
- Alarm Trap
- Alarm Count
- Main Element Name
- Active Alarms in System
Audio Page
This page displays the Audio Block Table, which contains information about all audio I/O blocks.
It also allows you to configure certain parameters, such as Incoming and Outcoming Format, SRC, Peak and Max Level, Alarms, etc.
Audio Processing - Embedder Page
This page displays the Audio Proc Table, which contains information about the audio processing capabilities of each card. You can configure the Mode and view the Audio Proc, Inputs and Outputs.
This page also displays the Embedder Table, which lists all embedders for those modules that have them. You can configure the Status, Word Length, and Alarms, as well as enable or disable the Embedder.
Laser Page
This page displays the Laser Table, which contains information about laser parameters.
It also allows you to view the Laser Num, Wavelength, Power and Type, as well as to configure the Config, Status and Alarms.
Reclocker Page
This page displays the Reclocker Table, which contains information about reclocker parameters.
It also allows you to view the Reclocker Num, Status and Bit Rate, as well as to configure Config, ASI, Bandwidth and Alarms.
Signal Input Page
This page displays the EQ Table, which contains information about EQ parameters.
It also allows you to view the Num and Status, as well as to configure Config and Alarms.
Signal Integrity Page
This page displays the Monitor Table, which contains information about monitor parameters.
It also allows you to configure Monitor Alarm, Error Count, Error Delta and Error Free Alarm, FF-CRC, AP-CRC, LOCK, ANCS, etc.
Voltage Page
This page displays the Voltage Table, which contains information about voltage measurements.
It also allows you to configure the Upper and Lower Limit and Alarms, as well as to view the Nominal effect and the Value in Volts and Watts.