Nevion Flashlink Frame - AV-SD-XMUX
This exported connector shows data from an AV-SD-XMUX module in a Nevion Flashlink frame.
About
This is an SNMP connector that is automatically generated by the parent connector Nevion Flashlink Frame.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Basic range | No | Yes |
| 2.0.0.x | Tree controls added to monitor parameters. | No | Yes |
| 2.0.1.x | Audio Block status fix (ONLY for firmware 2.0.4). | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 2.0.1.x | 5.0.4 |
Installation and configuration
Creation
This connector is used by DVE child elements that are automatically created by the parent connector Nevion Flashlink Frame.
Usage
General Page
This page contains general information about an AV-SD-XMUX module, including:
- Type
- Card Status
- Chassis Number
- Slot Number
- Label
- Alarm Status
- Alarm Trap
- Alarm Count
- Main Element Name
- Active Alarms in System
Voltage Page
This page displays the Voltage Table, which contains information about voltage measurements.
It also allows you to view the Upper and Lower Limit and Alarms, as well as the Nominal effect and the Value in Volts and Watts.
Optical Input Page
This page displays the Optical Input table, which contains information about optical input parameters.
It also allows you to view the Opt Input, Input Status and Signal Strength, as well as to configure the Opt Input Alarms.
Reclocker Page
This page displays the Reclocker Table, which contains information about reclocker parameters.
It also allows you to view the Reclocker Num, Status and Bit Rate, as well as to configure Config, ASI, Bandwidth and Alarms.
Monitor Page
This page displays the Monitor Table, which contains information about monitor parameters.
Delay Page
This page displays the Delay Table, which contains information about delay parameters.
It also allows you to configure the Status, Lines, Samples and Nanosecs delays.
Audio Processing - Embedder Page
This page displays the Audio Proc Table, which contains information about the audio processing capabilities of each card. The table allows you to configure the Mode and view the Audio Proc, Inputs and Outputs.
This page also displays the Embedder Table, which lists all embedders for those modules that have them. This table allows you to configure the Status, Word Length, and Alarms, as well as to Enable or disable the embedder
Audio Page
This page displays the Audio Block Table, which contains information about all audio I/O blocks.
It also allows you to configure certain parameters, such as Incoming and Outcoming Format, SRC, Peak and Max Level, Alarms, etc.
GPIO Page
This page displays the General Purpose Input Output Table, which contains information regarding I/O blocks.
It also allows you to configure the Mode, Status, Description and Alarms.